For baby swimming pools, The autumn and winter seasons are peak seasons each year.

When the peak season is approaching, The passenger flow of the baby swimming pool has increased significantly.

In order to serve the baby more efficiently, The cleaning and maintenance of baby swimming pool equipment is essential.

During the peak operating season of the store,

Any equipment damage will result in huge economic losses.

Next, the editor will introduce the daily maintenance of various equipment in the baby swimming pool.

Help the baby swimming pool peak season more prosperous!

First of all, the heating equipment, air energy, etc. of the baby swimming pool, When using in winter, remember not to power off the air energy engineering equipment and the water circulation system without water.

The heating engineering system keeps the water system circulating normally.

Automatic drainage system can be added to areas with severe cold and sudden power outages.

Automatic drainage after power failure to prevent freezing after power failure.

In case of power failure due to uncontrollable reasons or not in use in winter, The water in the main engine and circulating pump must be drained immediately after the power is cut off,

Otherwise, the host and circulating pump may freeze and be damaged.

When the low temperature of rain and snow continues, it is required to keep the air energy equipment free of water and snow.

During the daily use of the boiler,

Be careful not to place flammable and explosive materials around the boiler.

Clean the boiler frequently to avoid accumulation of dust.

And check the boiler oil tank, oil pipe, burner, etc. for oil leakage at any time.

In addition, Also regularly check whether there is water leakage on the water pipe and furnace body of the oil-fired boiler.

Do daily maintenance work,

Once the oil-fired boiler fails, it should be repaired and maintained immediately to avoid greater losses due to equipment failure.

Children’s swimming pools use the inner wall of the pipe for a long time to easily precipitate impurities in the water

If it is not cleaned for a long time, bacteria will grow, the water will turn white and yellow, produce peculiar smell, block the pipeline,

Seriously affect the normal opening of the function, causing the heating equipment to malfunction.

The cleaning steps are as follows:

1. Take out the swimming pool filter element:

2. Leave a proper amount of water in the swimming pool,

The lowest water level of the circulation system can be opened (the water level is 5cm above the filter port).

3. Put the pool pipe cleaning agent,

(2 tons of water is mixed with 1 bottle, and 1.5 bottles can be added in serious cases) Pour into the pool.

4. Turn on all functions of the pool:

Surfing, bubble, cycling, heating, etc.

5. The water temperature is heated to 40 degrees and kept at constant temperature for 3 to 4 hours.

6. During the cleaning process, large pieces can be removed first to avoid circulation back into the pipeline.

7. Until all the dirty stuff is exhausted, Change the water and inject new water, repeat the above steps for 1 hour, Wash off the residue, then drain the water, brush the pool to clean it.

8. Inject new water, put it into use, and complete.

If you want to remove the stains on the children’s pool, Just use a towel dipped in toothpaste, Just wipe the stained areas in the children's pool.

Winter maintenance of baby swimming rings is also very important.

Generally speaking, The best inflation degree of baby swimming ring is about 80%, Too high or too low will affect the baby's comfort when swimming, It even reduces the life of the swimming ring.

The temperature is low in winter, Will cause the flexibility of the swimming ring to decrease, Before use, you need to check for damage and air leakage. Then soak in warm water of about 40℃ and inflate for use.

Baby swimming pool as a service industry, Swimming equipment is the foundation, Must do basic daily maintenance, In order to provide consumers with good services, Satisfy customers!